Publicité
Les langues disponibles
Les langues disponibles
Before starting the control unit, disconnect the power supply and be sure it will not be connected again! Beware that there is no electric supply!
Electrical connections have to be done by a specialised technician only and complying with the relevant legislation. Do not use the control unit
when the packaging has visible damages.
Danger
Clamps are protected by a plastic cover. Be sure the power supply is off before opening it.
Low voltage wires have to be set apart from high voltage wires. Insert temperature probe wires on the left side of the control unit only and the
current wires on the right one.
Warning
The costumer has to provide for a disconnection device for all the poles, for example a circuit breaker.
Warning
The wires that are connected to the control unit must not be uncovered for more than 55mm and their covering must fit in the protection up to the
other strip extremity.
Warning
The control unit and the VFS probe have to have the same mass potential. The VFS probe has a functional ground system (PELV). The PE output
of the control unit has to be connected to the pipe beside the probe.
Warning
RC
VFS2 VFS1
Warning
max. 12V
230 V
F
N
6 A
22004022 - 06.13
7. Control panel description
esc
CAN CAN
PF-Relais
Relais
RSR-X
RSR-OP
RSR-OP
BYPASS PRIM. 1"1/2 DEV. 3 VIE
N
N
Assembling instructions and maintenance
SD Card Slot
for Data logging and firmware updates
Be sure that the SD Card is properly inserted!
The card has to be inserted with no pressure!
Warning
Ethernet
for LAN operations
Netz/Mains
current
230VAC
Pericolo
FRAME
INTELAIATURA
Circ. sec. Stratos Para 30/1-8
Pumpe sek. STRATOS PARA 30/1-12
Pumpe sek. STRATOS PARA 30/1-8
Circ. prim. Stratos Para 30/1-12
26
Publicité
