Installation - Zanussi ZFT11101WA Notice D'utilisation

Problem
It is too cold inside the
freezer
The appliance does not
work at all. Neither cool-
ing nor lighting works
The appliance does not
cool at all
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
This appliance should be installed in a dry,
well ventilated indoor where the ambient tem-
perature corresponds to the climate class indi-
cated on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
www.zanussi.com
Possible cause
Products to be frozen are placed
too closely to each other
Temperature regulator may be set
incorrectly
Plug is not connected to the mains
socket properly
Power does not reach the appli-
ance
The appliance is not switched on
There is no voltage in the mains
socket (try to connect another ap-
pliance into it)
Plug is not connected to the mains
socket properly
There is no voltage in the mains
socket (try to connect another ap-
pliance into it)
The appliance is not switched on
Place the products in a way so that
cold air could circulate among them
Set a warmer temperature
Connect the mains plug properly
Try connecting another electrical
device to the power outlet
Switch on the appliance
Call an electrician
Connect the mains plug properly
Call an electrician
Switch on the appliance
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Some functional problems might occur for
some types of models when operating outside
of that range. The correct operation can only
be guaranteed within the specified tempera-
ture range. If you have any doubts regarding
where to install the appliance, please turn to
the vendor, to our customer service or to the
nearest Service Centre
Solution
21