Zanussi ZFT11101WA Notice D'utilisation page 23

Masquer les pouces Voir aussi pour ZFT11101WA:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

1. Remove the plug
from the power sock-
et.
2. Tilt back the appli-
ance carefully so that
the compressor can-
not touch the floor.
3. Unscrew the left
foot.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the cab-
inet. In that case, wait for the natural fitting of
the gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest Af-
ter Sales Service Force. The After Sales Serv-
ice specialist will carry out the reversibility of
the doors at your cost.
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate cor-
respond to your domestic power supply.
www.zanussi.com
4. Remove the lower
door hinge by un-
screwing the 2 retain-
ing screws.
5. Remove the hinge
pin from the bottom of
the door.
6. Slot the hinge pin
into the hole in the
hinge plate.
7. Take the door off.
8. Refit the upper
hinge pin into the op-
posite location.
9. Fit the door in
place on the hinge
pin.
10. Slot the hinge pin
into the hole in the
hinge plate and relo-
cate the hinge assem-
bly to the opposite lo-
cation and refit using
the retaining screws.
11. Refit the bottom
hinge plate assembly
on the opposite side,
taking care that the
edge of the door is
parallel with the side
of the cabinet.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power supply
socket is not earthed, connect the appliance
to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
12. Remove and in-
stall the handle (if
foreseen) on the op-
posite side.
13. Reposition, level
the appliance, wait for
at least four hours and
then connect it to the
power socket.
23

Publicité

Table des Matières
loading

Table des Matières