Specifications; Mounting - HEIDENHAIN ND 1200R Radial Guide D'installation

ND 1200R Radial
Installation Instructions
Operating Instructions available at www.heidenhain.de

4. Specifications

The ND 120xR is an advanced digital readout (DRO) system for radial drilling machines
using analog or TTL encoders.This unit is designed for indoor use only. The ND 120xR
components shall only be installed as described in these instructions. Mounting,
installation and maintenance are to be performed by qualified personnel only.
Power input:
Replaceable fuse:
Environmental conditions
Operating temperature:
Storage temperature:
Relative humidity:
Altitude:
Protection:
Overvoltage category:
Pollution degree:
Mass:

5. Mounting

The following items are included with the product:
• Power cord
• Stand or mounting adapter
• ND 1200R Radial Installation Instructions
The following accessories are available for this product:
• Foot switch, ID 681041-01
• Remote keypad, ID 681043-01
• Stand, ID 382892-02
• Mounting adapter, ID 682419-01
Refer to " Accessories and connector pin assignments" on page 116 for additional
information. Refer to the instructions provided with an accessory for additional
information.
Do not mount in a position that makes it difficult to access the power switch or
power cable.
AC 100 V ... 240 V (-15 % ... +10 %)
50 Hz ... 60 Hz (±3 Hz)
(max. 100 W)
T 1.6 A / 250 V, 5 mm x 20 mm
Quantity: 2
0 °C ... 45 °C
-20 °C ... 70 °C
† 80 %
† 2000 m
IP00, front panel IP40
II, equipment intended to be supplied from the building
wiring
2
ND with stand: approx. 4.8 kg
ND with mounting adapter: approx. 2 kg
13