Jøtul F 305 R B Manuel D'installation Et D'utilisation page 20

ENGLISH
Fig. 6
1. Take the approval label (A) out of the ash pan and fasten
it with the nut (B), as displayed. The nut needs to be
tightened only with the fi ngers. NB: Do not cut off the
wire used for fastening the label.
4.2 Prior to installation - Jøtul F 305
with base
Fig. 7
2. If external air supply is not used, the external air connector
(A) can be unscrewed, if desired. Remove the four screws
used for fastening the external air connector and then the
connector itself. (For products with base: If necessary, you
can unscrew the heat shield beneath the burn chamber
in order to facilitate the dismantling of the external air
connector.
20
A
B
A
Fig. 8
1. First remove the outside air cover (A) by unscrewing the
screws (B).
Fig. 9
C
A
2. Remove the gloves from the ash pan.
3. Lift the baffl e, ash retainer, and bag of screws out of the
burn chamber.
4. Check that the control handles (C) move freely.
5. Remove the bottom plate (A) by taking hold of the front
left corner. Lift up the plate and remove it from the base
at an angle.
6. Remove the four transport screws (B) that fasten the oven
to the wooden pallet.
7. Lift the oven from the pallet and set it up (see fi g. 1).
B
A
B