Baumer TE2 Manuel De Mise En Service page 5

5.2 Mounting for hygienic applications
DANGER
Risk of injury from hazardous medium
Only use weld-in sleeves or adapters from Baumer.
f
„
Wear protective equipment for hazardousous media (e.g. acids, alkaline solutions).
f
„
Do not seal the process connections with Teflon Tape or elastomer.
f
„
Empty vessel and pipe before mounting.
f
„
Check leak-tightness of the sleeve.
f
„
Check tightness of the M12 plug.
f
„
Example of mounting with weld-in sleeve ZPW3-321
www.baumer.com
1
1
1
2
Operating Instructions
Temperature measurement
TE2
Compact RTD temperature sensor
9 Hole for mounting the sensor is easily accessible
Mount weld-in sleeve or adapter as follows:
f
„
3-A mark or arrow points upwards
„ „
Hygienically and internally flush
„ „
Grind welding to Ra ≤ 0.8 μm.
f „
Screw in sensor.
f „
Tightning torque:
G 1/2 A hygienic: 15 ... 20 Nm
„ „
M12 x 1.5 hygienic: 12 ... 16 Nm
„ „
M12 x 1.5 hygienic with PEEK cone:
„ „
8 ... 12 Nm
G 1/8 male thread hygienic: 10 Nm
„ „
1 ZPW3-321
2 Leakage hole
5 / 32