OHAUS TD52 Manuel D'instruction page 4
Masquer les pouces
Voir aussi pour TD52:
- Manuel d'instruction (148 pages) ,
- Mode d'emploi (56 pages) ,
- Manuel d'instruction (120 pages)
Publicité
Les langues disponibles
Les langues disponibles
EN-2
2.2 Installation procedure
Follow the steps below. Refer to the figures when performing these steps.
For TD52P:
1.
Separate the indicator from the base by disconnecting the load cell cable from the male
connector at the back of the Indicator. Remove the interface option cover.
2.
Connect the 7-pin Li-ion Battery Pack power cable to the main board battery connector
as shown.
Interface option cover
Load cell cable male connector
Cable
Battery Connector
Arrow
Publicité
