Adding Or Replacing A Hard Drive - eMachines H3120 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

www.emachines.com

Adding or replacing a hard drive

Tips & Tricks
You need a Phillips screwdriver to add or
replace a hard drive.
Slide the card reader out of the case.
5
Slide the new card reader into the bay from the front of the case.
6
Connect the new card reader's USB cable to the system board.
7
Use the screw you removed previously to secure the card reader to the bay.
8
Replace the front bezel by following the instructions in
9
front bezel" on page
Replace the side panel by following the instructions in
10
panel" on page
147.
To add or replace a hard drive:
Remove the side panel by following the instructions in
1
panel" on page
144.
If you are adding a new drive, go to
2
drive, go to the next step.
Disconnect the power and data cables from the back of the hard drive.
3
Adding or replacing a hard drive
147.
Step
4. If you are replacing an existing
"Replacing the
"Replacing the side
"Removing the side
153

Publicité

Chapitres

Table des Matières
loading

Table des Matières