GARDEO PRO GPTRT3735BAG Traduction Des Instructions Originales page 92

Spiked bumper
Device placed in front of the mount point of the bar and rotates when
it is in contact with a tree or log.
1、 Nut
2、 Clutch cover
3、 Spiked bumper
4、 Tapping screw
Mounting the claw
chaîne
5. clutch
6. Hole of the guide bar
7. tensioner
8. Brake connector
9. Direction to tension the chain
10. Front hand guard (brake lever)
1. Loosen the chain brake
2. two nuts
3. Clutch
(1) Claw slaughter
(2) Two bolts
�
Unscrew the two nuts and remove the cover
�
Ask the spiked bumper on the machine
�
Tighten the two bolts (2)
�
Install guide bar and drag chain.4. Guide-
�
Fit the chain as shown.
(Make sure the teeth are pointing in the right
direction)
�
release the brake system, then install the clutch
cover by positioning pins on the guide bar.
Hand tighten the two nuts.
Make sure the chain tensioner
properly in place in the hole in the chain guide.
�
Align the connector brake of the clutch housing
on the side of the groove on the front hand guard.
92