Configuring Your Software - Dell PowerVault NX1950 Guide D'installation

®
• Broadcom
card (NIC) with TCP/IP Offload Engine (TOE) or Intel
PT dual-port server adapter for additional client network connectivity
(a total number of four Gigabit Ethernet data connections are available)
• Dell Remote Access Card (DRAC) 5 for remote restore capabilities
and lights-out management
For information on setting up your hardware or racks, see the following
documents on the Dell Support website at support.dell.com:
• Dell PowerVault NX1950 Systems Getting Started With Your System
• Dell PowerVault NX1950 Systems Hardware Owner's Manual
• Dell PowerVault MD3000 documentation
• Dell|EMC storage array documentation

Configuring Your Software

Depending on the solution that you have purchased, Dell has
pre-configured the following software:
Table 1-1. List of Pre-Configured Software
Integrated Solution
Windows Unified Data Storage
Server 2003, x64 operating system
PowerVault MD3000 Modular
Disk Storage Manager
PowerVault MD3000 Volume
Shadow-Copy Service (VSS)
and Virtual Disk Service (VDS)
providers
Dell Storage Initialization Wizard Dell Storage Initialization Wizard
NetXtreme II™ 5708 single-port Gigabit network interface
SAN Gateway Solution
Windows Unified Data Storage Server
2003, x64 operating system
®
EMC Navisphere
command line interface (CLI)
Dell|EMC VSS and VDS providers
EMC PowerPath
licensed from Dell. For more information,
see "Registering PowerPath for the SAN
Gateway Solution" on page 24.)
EMC Storage System Initialization Wizard
Java Runtime Environment (JRE)
®
PRO/1000
®
Agent and
®
(This version is not
Introduction 7