3.5 Tool Composition; Technical Data; Safety Devices - CAMPAGNOLA T-REX Manuel D'utilisation Et D'entretien

3.5 Tool composition

Pos. Denomination
Chain
1
2 Bar
3 Locking nut
4 Adjusting screw
5 Front guard
6 Releasing switch
7 Operating lever
8 Hand guard
9 Battery connector
10 ON/OFF button
11 Handle
12 Plug with built-in rubber bulb
13 Chain guard
Lubricating oil reservoir
14
15 Bar guard
16 Battery
17 Releasing plates
18 Battery charger
19 LED light indicators
20 Recharge connectors
3.6

Technical data

Dati tecnici
Bar length:
4" bar maximum cut:
Cutting chain:
Active safety device
Variable speed
Chain speed
2.5 Ah battery cutting performance
4 Ah battery cutting performance
Battery rated/ max. voltage
Li-Ion battery
Charge voltage
Charge duration
Tool weight w/o battery
2.5 Ah battery weight
4 Ah battery weight
Total tool weight
3.7

Safety devices

• ON/OFF button (10): Switches the tool on and off.
• Releasing switch (6): Engages itself automatically when releasing the operating lever (7) and prevents from any
accidental tool operation.
• Bar guard (15): Protects the cutting bar (2) during transport.
• Chain guard (13): Protects the operator against any kickback effect.
• Hand guard (8): Protects the operator's hand against any contact with the chain (1), if this should break or get out
of the bar.
Page. 32
Function
Cuts branches, trunks, etc
Drives the cutting chain
Locks the bar
Regulates the chain tension
Protects the pinion and the bar chain
Allows to start the tool safely
Is pressed to operate the tool
Protects the operator's hand from the risk of touching the chain
Allows to connect the tool to the battery.
Switches the tool on and off
Allows to hold the tool
Allows to manually lubricate the chain and closes the oil reservoir
Protects the operator from any kickback
Contains the oil for the bar and chain lubrication
Protects the chain when the tool is not used
Allows to operate the tool
Allow to insert the battery into the tool or to remove it
Charges up to three batteries in sequence
Show the battery charge status
Connect the battery charger to the battery
4"
Ø 100 mm
29 teeth, 1/4"
YES
YES
8.5 m/sec
Approx. 90 cuts of 8 cm Ø
Approx. 150 cuts of 8 cm Ø
21.6 V / 24 V
2.5 Ah and 4 Ah
AC110V-220V
1.5-3 h each battery
1000 g
330 g
480 g
1330 g / 1480 g
Use and maintenance manual – Translation of
original Instruction.: 01, Date 04/11/2021