HK Audio elements E 435 Manuel D'utilisation page 8

Elements 1.1
3
Sensitivity
Input
Through
4
E 110 Sub A
Powered Subwoofer
Made in Germany
5
Green = On
Red = Limit/Error
Power
Caution: Risk of electric shock!
6
Do not open! Refer servicing to
qualified service personnel.
Serial No.
Mains
7
Caution: To reduce the risk of
electric shock, grounding of
the center pin of this plug
must be maintained.
8
Speaker Out
1
Min. imp. 8 Ohms
1 2
300 Watts
2
5 Limiter Status LED
This dual-color LED shows the signal's status: green
= signal; red = limiter. The LED lights up red to
indicate signal peaks at high volumes.
Caution! This is not a clip LED. It's okay if it lights up
red briefly every now and then. This tells you that the
RMS limiter has engaged. If the LED always lights up
red at signal peaks and no audio signal is audible,
check the input level at the signal source – this may
indicate a problem at the source.
6 Power Switch
When you switch the system's amp on, the Signal
LED lights up red for about five seconds, and then
changes to green, indicating the amp is ready to
1 operate.
7 Mains Input
2
Use the factory-included locking mains cord to
+4 dB
connect this socket to a wall outlet. The catch
-10 dB
holds the plug in place to prevent accidental or
unintentional removal from the socket. To unplug
the cord, press the yellow spring-loaded lock at the
bottom of the plug to release this catch.
Note: This socket also accepts a conventional IEC
cable, but of course the catch will not lock it in place.
Caution! Ensure all power amps (EA 600, E 110
Sub A) are switched off before connecting other
ELEMENTS components, otherwise they may be
damaged! Always set the entire system up first
before you switch on EA 600 power amps and active
E 110 Sub A subwoofers.
Caution! Make sure the local mains voltage matches
the voltage specified on the E 110 Sub A. Connecting
it to the wrong mains voltage may destroy the amp's
electronic components.
8 Speaker Out
Use this Speakon NL4 port to connect one passive
E 110 Sub subwoofer or up to two E 435 mid/high
units; see section 2.1 for more on this.
9 E-Connect
E-Connect is a novel combination of audio bus and
mechanical coupler that connects the E 110 Sub A to
other components. The beauty of its integrated bus
is that it takes the place of speaker cords. E-Connects
are located in the subwoofer's top panel as well as in
the active subwoofer's left panel, the latter enabling
the enclosure to be placed sideways.
Connecting components: The module that you wish
to connect has an E-Connect coupler on its bottom
panel. Insert it into the subwoofer's E-Connect
sleeve. The top mid/ high unit's E-Connect shaft
has a detent button that locks into place in the
subwoofer's E-Connect sleeve. This mechanism
connects the two components physically and routes
the signal to speakers without outside cords.
Press the detent button to separate the two
components when dismantling the column.
The power amp provides plenty of juice to drive one
additional passive ELEMENTS E 110 Sub subwoofer
or up to two ELEMENTS mid/ high units.
You can set up a subwoofer in two ways depending
on operating mode and system configuration.
Four rubber feet on the bottom panel provide
stable support when the enclosure is in the upright
position. The E 110 Sub A's housing has two runners
on one side panel and two matching channels routed
into the opposite panel that allow you to safely stack
several subwoofers sideways.