Philips MANT901 Manuel D'utilisateur page 7

Assembly
• Attach one 46˝ Element to hole A in VHF Boom-B.
• Attach one 50˝ Element to VHF Boom-B.
Repeat each steps with second boom for VHF Boom-B.
• Insert VHF Boom-B into VHF Boom-A and secure
• Attach tubing brace to rear of VHF Boom with 1-
• Slide UHF Boom through center slot of VHF Boom
• Attach phasing wire and lead-in wire to UHF antenna
• Insert end caps at ends of all booms.
Mast Assembly (Mast not included)
• Assemble U-bolts to cross pieces.
• Use saddle on center of boom.
using 1-1/2˝ screw and lock washers. Repeat steps
for 2nd boom as well.
1/2˝ screws and wing-nuts.
support block until hole A of UHF Boom aligns with
hole B of VHF Boom. Secure with 1-1/2˝ screw
and wing-nut.
using 3/4˝ screws, washers, and wing-nuts.
EN
7