Philips MANT901 Manuel D'utilisateur page 6

EN
6
Assembly
Assembly of UHF Portion
• Rotate reflector element rods into place. NOTE:
When rotating element rods, grasp close to pivot
and relieve spring pressure on pivot bracket
detents. Don't apply excess pressure to reflector
element rods.
• Insert UHF Boom-A into UHF Boom-B and secure
using
1-1/2˝ screw and lock washer.
• Attach Reflector Arm Mounting Brackets to assem-
bled UHF Boom (previous step) using two 1-1/2˝
screws and wing-nuts. Ensure that rotation arcs in
Reflector Arm Mounting Brackets face toward UHF
Boom elements.
• Attach Corner Reflector Arms to Reflector Arm
Mounting Brackets by sliding Reflector Arms
between Mounting Brackets. Secure with 1-1/2˝
screw and wing-nuts. To fully secure Reflector
Arms, snap into locking tabs and tighten screws.
Assembly of VHF Portion
• Rotate reflector element rods on VHF Boom-A and
VHF Boom-B into place. NOTE: When rotating ele-
ment rods, grasp close to pivot and relieve spring
pressure on pivot bracket detents. Don't apply
excess pressure to reflector element rods.