Maintenance - Husqvarna 115iHD45 Manuel D'utilisation

To use the SavE function
This product has a power saving function, SavE.
Note: The SavE function does not decrease the cutting
power of the product.
1. Press the SavE button on the keypad.
2. Make sure that the green LED comes on.
3. Press the SavE button again to disconnect the
function. The green LED goes out. (Fig. 35)
Automatic shutdown function
The product has an automatic shutdown function that
stops the product if it is not used. The green LED for
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance work on
the product.
WARNING: Remove the battery before you
do maintenance on the product.
779 - 001 - 08.07.2019
start/stop indication goes off and the product stops after
45 seconds.
To stop the product
1. Release the power trigger or the power trigger
lockout.
2. Press the start/stop button until the green LED goes
out.
3. Press the release buttons on the battery and remove
the battery. (Fig. 36)

Maintenance

Maintenance schedule
The following is a list of the maintenance steps that you
must do on the product.
11