Initial Use; Unpacking The Air Dehumidifier; Setting Up The Air Dehumidifier; Operation - Beurer LE 60 Mode D'emploi

Control unit with LED indicators
1
1. ON/OFF button (switches the device on/off)
2. MODE button (∞, VALUE)
3. LOCK button (switch button lock on/off)
4. SET button (air humidity setting)
5. Ioniser button (switch ioniser on/off)
6. SWING button (switch swing function on/off)

5. Initial use

5.1 Unpacking the air dehumidifier

1. Open the cardboard packaging.
2. Remove the device from the top of the box without opening the film bag.
3. Now remove all plastic films.
4. Check the device, mains plug and cable for damage.

5.2 Setting up the air dehumidifier

1. Place the air dehumidifier on a firm, level and water-resistant surface to prevent vibrations and noise.
2. Set up the air dehumidifier in such a way that provides 30 cm clearance on all sides.
3. Ensure that the ventilator air supply and ventilator air delivery are never blocked.
4. Insert the mains plug into the socket. Ensure the cables do not pose a trip hazard.
5. Before using the device for the first time, it should be left in an upright position for at least 2 hours (how-
ever ideally 24 hours).

6. Operation

6.1 Switching the air dehumidifier on/off

1. Insert the mains plug into a suitable socket. The air dehumidifier issues three acoustic signals.
2. To switch on the air dehumidifier, press the POWER button. The swing flap opens and the device starts
continuous dehumidifying at high fan speed (II).
3. To switch off the air dehumidifier, press the POWER button again. The air dehumidifier stops dehumidifying
and the swing flap closes again.
Notes on operation
If the device has fallen over or if you have changed the location of the device, you should leave the
device to rest in an upright position for at least two hours.
9
3
2 4
11
5
6 7
7. FAN SPEED button (I or II)
8. TIMER button (1H, 2H, 4H, 8H, off)
9. Defrost function active
10. Full water tank
11. Target air humidity
18
10
8