THOMSON CR221I Mode D'emploi page 16

Sleep
NOTE:
The system must be "Turned On" in order to set the sleep timer
1. Press the "SLEEP" button to enter.
2. Press the "SLEEP" buttons to set SLEEP time (120, 110, 100... OFF)
3. To cancel SLEEP, follow above step 1 to 2 and set the SLEEP time to "OFF".
Listening to the FM Radio
1. Press the "STANDBY" button to turn on the device to listen the FM radio.
2. For FM reception: Completely extend the telescopic antenna. Change its position to improve the reception.
3. There are two options to search for and preset radio stations.
• Automatic scan for FM stations:
Press the "SKIP +" or "SKIP -" buttons for approx.2 seconds, the device will search to the previous
or next radio station respectively.
• Manual scan for FM stations:
Briefly press the "SKIP +" & "SKIP -" buttons, until you have found the radio station which you are
looking for.
• Automatic preset station:
1. Press and hold the "CLK. / MEM." button on unit for about 2-3 seconds to start the automatic preset
process.
2. Display will show the memory sequence number and radio stations will be automatically preset
into the sequence number (Note: Each sequence number means 1 preset station while during
automatic preset process.)
3. Once all the stations were preset, press the "PRE." button until you see memory sequence number.
4. Press the "SKIP +" & "SKIP -" buttons to search for the desired preset station.
5. Press "PRE." button to confirm and listen to your desired radio stations.
• Manual memory preset
1. Search for a station as described in "Automatic scan for FM stations" or "Manual scan for FM stations".
2. Press "CLK. / MEM." button to enter manual preset station setting.
3. Display will show "P01" flashing.
4. Press " SKIP +" or "SKIP -" buttons to choose preset station number.
5. Press "CLK. / MEM." button to confirm chosen preset station number.
6. Once all the stations were preset, press the "PRE." button until you see memory sequence number.
7. Press the "SKIP +" & "SKIP -" buttons to search for the desired preset station.
8. Press "PRE." button to confirm and listen to your desired radio stations
Importance Notice
Due to the interference from wireless charging, the wireless charging function will be suspended under
the FM radio mode.
Charge Your Phone
You can charge your phone via wireless charge or USB charger slot(cable not included).
Wireless charge
1. Place your smartphone centrally on top of the device as shown.
2. The charge state is indicated in your smartphone display as usual.
NOTE:
• If problems occur when charging or if the charging does not start:
- Remove your smartphone from the case, if the thickness of the case exceeds 5mm or if it consists of metal.
- Check if your smartphone is placed on top of the device as shown.
- EN 6 -