Using Your Electronic Control - Marvel MA15C Série Instructions D'installation, D'utilisation Et D'entretien

On/off
Display icons:
appliance on and off.
functions in the user interface.
on and off, glass door models only.
vacation mode.
the user interface.
Display area text:
ICE
ice.
ECO
production mode.
OFF
DOOR
Cleaning is recommended or the appliance
CLEAN
is in the clean mode.

USING YOUR ELECTRONIC CONTROL

Menu Display area
ICE
1 4 6 8
hours
days
OFF CLEAN
Figure 22
User interface display
Light
DOOR
ECO
Delay start/Vacation mode:
hours
1
days
Hours or days timer is set for
Hours or days will be lit
operational.
NOTE
The control display is covered with a clear plastic protective
corner.
Starting your clear ice machine:
Plug the ice machine into a 115 volt wall outlet,
(see page 5 for electrical information). Your
appliance is shipped from the factory in the "ICE" mode
and will begin start-up of ice production after the start-up
routine.
Upon applying power to the unit, or after a power
interruption, the Ice machine will perform a self-test,
followed by a harvest cycle to clear any in-process ice
production. This start-up routine, ("after power is applied
to the unit"), takes approximately 13 minutes to complete
before an ice production cycle starts.
power, and the control is in the "ICE" mode, (see Options
section below). Do not start the ice machine in "ECO"
mode. "ECO" mode should only be used after there is a full
bin of ice.
14
Delay timer Lock
4
6
8
ICE