Something Not Working - WYSS TUMBLER 6550 Mode D'emploi

125987711.qxp 2007-06-25

Something not working?

Before contacting your local Service Centre, please make the following checks:
• The dryer does not work:
• The dryer does not dry properly:
If, after the above checks, there is still a fault, call
your local Service Centre.
Please make sure you give the model and serial
10:45 Page 16
Problem Possible cause
The door(s) has (have) not been closed.
•
The plug is not properly inserted in the power
•
socket.
There is no current at the socket.
•
The main fuse or the fuse in the plug has blown.
•
The selector dial is not set correctly.
•
he water reservoir is full or not properly inserted
• T
(the "BEHÄLTER" light is on). The programme starts
in any case but it stops after approx. 4 minutes.
The START/PAUSE Button has not been depressed.
•
The STARTZEIT-VORWAHL option has not been
•
selected.
The laundry has not been spun properly.
•
The filters and/or the condenser are clogged up.
•
The water reservoir is full.
•
The room temperature is too high.
•
The selected time or drying cycle was not suitable
•
for the laundry.
The SCHON button has been pressed.
•
There is too much laundry inside the appliance.
•
The dryer is not correctly installed.
•
number of the appliance.
This information can be found on the rating plate
(see picture on page 4 ).
16