Operating Sequence - WYSS TUMBLER 6550 Mode D'emploi

125987711.qxp 2007-06-25

Operating sequence

Before using your tumble dryer for the first
time, we recommend to place a few damp
cloths inside the appliance and dry for 30
minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door (see picture).
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does
not get caught between the door and filter.
5. Select the drying programme or time. The lights
TROCKNEN, ABKÜHLEN and ENDE come on.
The light of the START/PAUSE button flashes
and the display shows the duration of the
programme.
6. If required, press the SCHON button and/or the
SIGNAL AUS button or the KURZ button.
7. Select the STARTZEIT-VORWAHL if required.
The selected delay appears on the display for 2
seconds, then the duration of the selected
programme is displayed.
8. Press the START/PAUSE button: the
corresponding light stops flashing and drying
starts. Only the TROCKNEN light stays lit. If you
have selected the STARTZEIT-VORWAHL, the
machine begins its countdown.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase (light ABKÜHLEN is on).
You may remove the laundry after this phase.
The ENDE, SIEBE and BEHÄLTER lights
illuminate and the buzzer sounds
The display shows a static zero.
9. If the laundry is not removed at the end of the
cycle, the dryer performs an anti-creasing
phase (duration: 30 minutes maximum).
10:45 Page 12
If you do not remove the laundry, the dryer will
stop automatically at the end of the anti-creasing
phase.
The ENDE, SIEBE and BEHÄLTER lights remain
lit and the buzzer sounds every 10 seconds for 2
minutes.
The light of the START/PAUSE button goes off
and a flashing zero appears on the display.
10.Turn the programme selector dial to "AUS"; all
the lights go out. The appliance is switched off.
Remove the laundry.
If you open and then close the door before
turning the programme selector dial to "AUS",
all the lights corresponding to the phases
making up the performed programme come
on and the display shows the duration of the
programme.
After each use
• Clean the filters (see page 14).
• Empty the water reservoir (see page 15).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
programme selector dial to position"ABKÜHLUNG"
and wait until the end of this phase before removing
the laundry. This will avoid a build-up of heat inside
the appliance. To do this first turn the dial to "AUS"
and then to and depress START/PAUSE Button .
Modifying the programme
To change a programme which is running, first
cancel it by turning the programme selector dial to
"AUS". Select the new programme and press the
START/PAUSE Button.
12