WYSS TUMBLER 6550 Mode D'emploi page 10

125987711.qxp 2007-06-25
9 Delay Start button - STARTZEIT-
VORWAHL
This button allows you to delay the starting of the
programme by 20 hours max.
This option must be selected after having selected
the programme and before pressing START/PAUSE
to start the programme.
Every time the button is pressed, the time is
increased by 30 minutes, until the display shows a
delay of "2 hours". After this, the delay is displayed
hour by hour.
The minutes or hours of delay that have been
selected are displayed for 2 seconds, then the
display shows the duration of the previously
selected programme.
The countdown begins after you have pressed the
START/PAUSE button.
To cancel the delay time press the START/PAUSE
button and after press the STARTZEITVORWAHL
button until the display indicates AUS'. Then press
the START/PAUSE button again.
When the delay is cancelled, the display shows 0'
and after the duration of the programme.
During the delayed start, it is not possible to change
the programme or the delay time that have been
selected. To do this, you must first switch off the
machine by setting the programme selector dial to
"AUS". Select the new programme, the options and
the delayed start, then press the START/PAUSE
button.
During the delayed start, to cancel or change
functions
that have been selected, simply set the
appliance to PAUSE. Once you perform the desired
operation, press once again the START/PAUSE
button.
If you wish to add more laundry while the machine is
performing the countdown, simply open the door.
This button must be depressed also after a power
failure and after having re-inseted the water
reservior, if it has been emptied in the middle of a
programme after ligting up of light BEHÄLTER
When you close the door, press the START/PAUSE
button again to cause the countdown to be
.
resumed
10:45 Page 10
10 Indicator lights
These lights indicate the following functions:
SIEBE light (Clogged filters)
This light illuminates at the end of the programme to
remind you that the filters must be cleaned.
BEHÄLTER light - (Full tank)
This light comes on at the end of the programme to
remind you that the water reservoir must be emptied
out. If this light illuminates during a programme this
means that the water reservoir is full. The buzzer
sounds, the programme stops, the light of the
Start/Pause button flashes.
KONDENSOR light - (Clogged condenser)
It comes on every 80 cycles to remind you that the
condenser must be cleaned.
10