Connect; Place The Unit; Connect Speakers; Connect Fm Antenna - Philips MCD712 Mode D'emploi

3 Connect

Place the unit

1
Place the unit near to the TV.
2
Place the left and right speakers at equal
distance from the TV and at an angle
of approximately 45 degrees from the
listening position.
Note
•
To avoid magnetic interference or unwanted
noise, never place this apparatus and speakers
too close to any radiation devices.
•
Never place this unit in an enclosed cabinet.
• Install this unit near the AC outlet where the
AC power plug can be easily reached.

Connect speakers

Note
•
Ensure that the colors of the speaker wires and
terminals are matched.
•
For optimal sound, use the supplied speakers
only.
•
Connect only speakers with impedance that is
the same or higher than the supplied speakers.
Refer to the Specifi cations section of this
manual.
1
Hold down the socket fl ap.
12 EN
2
Insert the stripped part of the wire
completely.
• Insert the right speaker wires to "
left speaker wires to " L".
• Insert the red wires to "
wires to " -".
3
Release the socket fl ap.
a b

Connect FM antenna

Tip
• For optimal reception, fully extend and adjust
the position of the antenna.
•
For better FM stereo reception, connect an
outdoor FM antenna to the FM AERIAL jack.
•
The unit does not support MW radio
reception.
1
Connect the supplied FM wire antenna to
the FM AERIAL socket on the unit.
R",
+", black
c