Extel eWatch Série Guide D'installation Rapide page 21

FACTORY DEFAULT SETTING
Press and hold the reset button on the power cable for 5 seconds and the system will start the
reset process. The system will restore to factory default and you may start the Wi-Fi setup.
SAFETY INSTRUCTIONS
Damage caused by the failure to follow the instructions in this manual lead to the termination of
the warranty. We cannot be held liable for the resulting damage!
We cannot be held liable for any damage to property or injury to persons cause by incorrect
handling or the failure to follow the safety instructions.
This product has been manufactured in full compliance with safety instructions. In order to
maintain this state of affairs and ensure the best use of the product, the user must follow the safety
instructions and warnings contained in this manual.
The person using this system is responsible for it and must check that the video surveillance
compiles with the laws applicable in the country of use.
- You must only use this product at a voltage included between: 100-240 Volts and 50-60 Hertz.
Never attempt to use the product with another voltage.
- Make sure that all the system's electric connections are compliance with the usage instructions.
- In commercial establishments, make sure you follow accident prevention rules for electric
installations.
- In schools, training infrastructures, workshops... the presence of qualified staff is required to
check the operation of electronic devices.
- Please contact an experienced person if you have doubts as to the operation or safety of the
appliances.
- Never connect or disconnect electric appliances with wet hands.
- When installing this product, check that the power supply cables are not in danger of being
damaged.
FCC/CE WARNING
Comment: This equipment has been tested and found compliant with the limits of a class B
appliance, in compliance with applicable European standards. These limits are designed to provide
reasonable protection from interferences in a residential installation. This equipment uses, and can
transmit radio frequency energy and, if not installed and used following instructions, can cause
interference to radio communications.
However, there is no guarantee that the interferences will not occur in a specific installation. If this
equipment causes interferences to radio or TV reception, which can be determined by powering
the equipment on and off, the user is encouraged to attempt to rectify the interferences using at
least one of the following methods:
• Redirect or move the receiver antenna
• Increase the distance between the equipment and the receiver
• Connect the equipment to a socket on a different circuit than the circuit the receiver is
connected to.
CFI EXTEL eWatch - 04/2017
GB4