Publicité
Les langues disponibles
Les langues disponibles
Preparing 6 and 4 cups respectively
1)
Fill water into the water container (10) up to the "6" mark and "4" mark respectively.
2)
Take the 6-cup or 4-cup fi lter funnel (9) and fi ll it brimful, but loosely, with ground espresso
powder (no ordinary coffee powder!!). Just smooth out the fi lling and do not press it into the
fi lter on any account!
3)
Insert the fi lled funnel in the water container.
4)
Remove any powder residues from the rim in order for the seal to close perfectly.
5)
Tightly screw together the upper vessel (3) and the water container (10) to prevent the
escaping of steam. Do not hold the coffee maker at the handle when doing so. Make sure the
upper vessel is not put on canted but straight.
6)
Put the can on the power base (14) and connect the plug to the electrical outlet.
7)
By pressing down the ON/OFF switch (12) the espresso maker is turned on. The indicator light
in the switch glows.
8)
Do not open the cover until the cooking process is fi nished.
9)
When the espresso is ready the ON/OFF switch (12) snaps back into the starting position, the
indicator light goes out and the appliance switches off automatically.
10)
Disconnect the mains plug.
11)
Now you can serve the espresso. Caution: Touch the espresso maker only on the heat-
insulated handle!
12)
If you would like to prepare another supply of espresso, let the appliance cool and then start
with the preparation again.
Preparing 3 cups and 2 cups respectively
1)
Fill water into the water container (10) up to the "3" mark and "2" mark respectively.
2)
Take the 6-cup or 4-cup fi lter funnel (9) and place the additional 3-cup fi lter insert or 2-cup
fi lter insert (8) respectively in it. Then fi ll it brimful, but loosely, with ground espresso powder
(no ordinary coffee powder!!). Just smooth out the fi lling and do not press it into the fi lter on
any account!
3)
Then proceed as per the preparation of 6 cups and 4 cups respectively, starting from point 3).
SOME TIPS
Perfect espresso is served and enjoyed in well preheated espresso cups!
•
Since the coffee is served directly from the appliance, slightly sway it before pouring out in order
•
to grant an equal consistence of the espresso.
Cleaning and maintenance
Prior to cleaning the unit, always disconnect the mains plug!
Allow unit to cool after use and then clean the accessory parts in hot water. For that you can
readily use a small, soft bottle-brush.
It is quite normal that there are some residues of water and coffee powder left in the water
container. However, never immerse water container (10) and power base (14) into water!
Do not use abrasives or cleaning sprays. Do not clean it in the automatic dishwasher!
Always let the appliance dry out completely; we therefore recommend that the appliance be stored
unscrewed.
The fi lter plate as well as the sealing rubber must be kept clean and be replaced regularly. You can
buy those as an accessory set in specialist shops or order from us directly under article no.
F 13.13 (ElPresso for 6/3 cups) and F 13.14 (ElPresso mini for 4/2 cups) respectively.
If scale deposits should form in the water container we recommend a digestible descaling
procedure with citric acid or vinegar.
OUR TIP:
Loose soiling in the water container (10) can be easily removed by fi lling half of it with warm water,
connecting it fi rmly with the top (3) and shaking it well.
7
Publicité
