Cembre CP1086-W-1000-KV Mode D'emploi page 5

2.2) Cutting head
The cutting head must be positioned manually around the cable to be cut based on the diameter
of the cable which has to be cut.
Select the appropriate cutting head for the diameter of the cable to be cut and use only with the
associated pump (see text).
To guarantee a permanent connection and resistance to the pressure developed in the system, the
flexible hose is screwed directly to the cutting head by means of a coupling which can be loosened
only by using a tool.
The cutting head is provided with an earth terminal (see figure).
TC 120-W...
TC 096-W...
TC 086-W...
e
arth terminal
2.3) Flexible insulated hose
The flexible insulated hose is used to deliver oil under pressure, generated by the pump, to the
cutting head and as an insulating element between the head and the pump.
It comprises a flexible insulated hose and connectors applied to each end.
The flexible insulated hose is completely filled with insulating oil.
2.4) Insulating oil
The insulating oil transmits the operating pressure of the pump to the cutting head. It is a special
hydraulic oil with properties which insulate the pump from the cutting head.
2.5) Quick couplers
The flexible insulated hose is fitted with a quick connector for connection to the pump without tools.
This coupling cannot be disconnected if the system is under pressure.
The anti-dust protection cap must be used on both hose and pump couplings to prevent ingress
of dirt or contamination.
5