Selecting A Track Via The Track-Buttons; Synchronisation Of The Playback-Speed - Omnitronic DSS-2 Mode D'emploi

6.5. Selecting a track via the Track-buttons

You can select the desired track via the Track-buttons.
In order to play a track from the beginning, press the Track-buttons until the desired track number is
displayed. If you hold the respective Track-button, the CD-player will run through the track numbers until you
let the button loose.
«-button:
If you press the «-button once, playback starts at the beginning of the previous track. If a track is already
played back, you can start the current track from the beginning.
+10-button:
By pressing the +10-button, the CD-player jumps 10-stepwise from track number to track number (e. g. 06,
16, 26, 06).
»-button:
If you press the »-button once, the playback starts at the beginning of the next track, if you press it twice the
following track, etc.
Please note that the CD-player calls the track up in the mode you pressed the Track-button. If the CD-player
is in the Play-mode at track 1 for example and you press the »-button, the player jumps to track 2 and
immediately starts playback.

6.6 Synchronisation of the playback-speed

You can synchronise the CD player and another signal-source while cueing with the headphones via the
mixer.
Possibility 1:
Put the CD-player into playback-mode and cue with the headphones. Synchronise the playback-speed via
the Pitchfader of the CD-player (Pitch-button has to be pressed).
Possibility 2:
If the two signal-sources only differ in the bass-beat, you can synchronise via the Pitch Bend-buttons or the
Scratch-wheel.
Put the CD-player into playback-mode and cue with the headphones. Synchronise the bass-beat via the left
or right Pitch Bend-button.
6.7 Programming
Create a program:
Press and hold the Stop-button for approx. 3 seconds. Press the Program-button and the Program-LED
shines. The display shows "- -" for indicating the track-number, "00:00" for indicating the track-length and
"01" for indicating the program-number.
Press one of the Track-buttons until the display will show the desired track number for the program-number
1. Press the Program-button in order to save the track.
Press one of the Track-buttons again in order to choose a track for the next program-number.
Continue programming like this until you have no more tracks to program or the maximum of programmable
tracks (30) is reached.
Check the program:
You can interrupt the programming procedure in order to check the program by pressing the Program-button
once more after you entered a track. Press the Program-button repeatedly and the display will show the
order of programmed tracks. You can edit every program-number and choose a different track.
Read a program:
After entering your last track, press the Program-button and the last track will be memorized. Press the
Play/Pause-button and the program will be played back. During the program-playback, the Program-LED is
shining. You can enter the Program-mode at any time in order to add more tracks by pressing the Program-
button.
Delete a program:
In order to leave the program mode press the Program-button and hold it for approx. 3 seconds or open the
CD tray or switch the device off. As soon as you deleted the program, the Program-LED is off.6.7 Cueing
29/64 10553155_V_1_0.DOC