Beko PSK Guide D'utilisation page 9

STEP 9 :
For the connection of TD and Stacking Kit assembly;
- Lift the TD by pushing it forward from the rear area. Install the rear fixing part (4) to retaining duct (1)
part. (9.1)
Rear retaining parts (4a-4b) have two types: left and right. Installation in the reverse direction is
not possible. Because rear fixing parts designed as left and right. (4a-4b)
STEP 10 :
Move the rear fixing parts (4a-4b) inside the retaining duct (1a-1b) as per the depth of TD.
- After this adjustment, use the screws removed in step 8 to secure rear retaining parts to TD body.
(10.1)
Use powered screwdrivers only during screw connection.
STEP 11 :
In order to complete the WM, TD and Stacking Kit assembly connections;
- Match the corresponding holes between parts no. 1 and 3 and connect these matching holes (2) with
plastic screws. (11.1)
- Complete Stacking Kit installation by making this operation in both directions.
4a
9.1
10.1
4b
1b
11.1
9 - EN
4a
9.2
4b
3b