Beko PSK Guide D'utilisation page 7

STEP 4 :
Place the rear support plate (3) ;
- on the retaining duct (1) as shown in figure 4.1 first. (4.1)
- Then adjust the hole positions on the WM body. (4.2)
Hint 1 :
As shown in figure 4.3, ensure that it properly
seated on the duct shown.
Hint 2 :
Find the proper screw position (4.4) by moving
it on the retaining duct (1) and mount them with the plastic
screws (2). (4.5)
4.3
STEP 5 :
In order to make the retaining duct (1a-1b) to WM body connection,
- As shown in figure 5.1, use the self tapping screw (5a) delivered with Stacking Kit assembly in order
to position the (3a) part on the WM body and perform the connection.
For the connection in this step, special design no. 5a screw is used only and
used for
the installation. (5.1)
3a
5.1
- As shown in figure 5.2, use the self tapping screw (5a) delivered with Stacking Kit assembly in order
to position the (3b) part on the WM body and perform the connection.
For the connection in this step, special design no. 5a screw is used only and
used for
the installation. (5.2)
If there is an installation hole on the body; use butt-end torx screw (5b) instead of drill-bit self-
tapping screw (5a). (5.3)
4.4
5a
5.2
7 - EN
4.1
4.2
3b
4.5
1 piece is
5b
5.3
1 piece is