Abus AZ4290 Instructions D'installation page 46

Training the Terxon 2WAY wireless module in a Secvest wireless indoor sounder
To train the Terxon 2WAY wireless module in a Secvest wireless indoor sounder, the Terxon 2WAY
wireless module must be ready to send a message to the Secvest wireless indoor sounder.
(As described in the preceding section).
Now leave programming mode. Press ESC/DEL until the Terxon 2WAY wireless module starts beeping
about once per second. Close and hold the lid tamper contact (SW4 underneath ESC/DEL) down for about
4 seconds until it beeps twice. The data is saved in an EEPROM.
Once you have done this, press SET to send the training signal to the Secvest wireless indoor sounder(s).
To train the Terxon 2WAY wireless module in several Secvest wireless indoor sounders in a row, press the
set button again each time.
Make sure that the Secvest wireless indoor sounder is activated, i.e. that a power supply (battery and/or
external power supply) is connected to the Secvest wireless indoor sounder and the "Learn" jumper is set
across both contacts. Remove this jumper after training. Set the jumper for selecting the partition. It does
not matter which partition is selected, but a partition must be selected. The Secvest wireless indoor sounder
will always respond then.
Menu 6 – not in use
Menu 7 – not in use
Menu 8 – Set default factory settings
Press SELECT until the 8th LED from the bottom lights up.
Push the SET button once to get to menu 8.
All blue LEDs start flashing. This display signals that the Terxon 2WAY wireless module is ready to reset
itself to the factory settings.
Push and hold the ESC/DEL button for about 4 seconds until the flashing stops and the Terxon 2WAY
wireless module beeps twice. The factory settings are now loaded again.
You are now back in the main menu.
If you want to close programming mode, press ESC/DEL until the Terxon 2WAY wireless module starts
beeping (about once per second). Close the Terxon 2WAY wireless module housing and hold the lid tamper
contact (SW4 underneath ESC/DEL) down for about 4 seconds until it beeps twice. The data is saved in an
EEPROM.
46