JENCONS Powerpette Notice D'emploi page 6

Recharging the POWERPETTE / POWERPETTE
Before starting to operate, carefully check mains voltage and recharge batteries.
POWERPETTE / POWERPETTE
To charge the
1 Recharging temperature +10°C to +35°C.
2 Plug the charger jack (6) into the base of the
3 Plug the charger (5) into a suitable wall socket. The red indicator on the charger will light up.
4 Place
POWERPETTE
5 Allow unit to charge for 14 hours from empty to fully charged.
6 Once the
POWERPETTE
charge operation and the red indicator will turn off. If the charge to the
interrupted and then re - started, the charger starts its full 14 hour charging cycle again.
This will not damage the battery.
Only use the charger indoors and protect against moisture.
Fitting the POWERPETTE wall bracket
The
POWERPETTE
from the double sided tape and pressing firmly to a grease free smooth surface. Alternatively,
it can be attached using the two stainless steel screws provided. Care should be taken in
positioning the screws.
Fitting the POWERPETTE
into the bench stand
The
POWERPETTE
of the two positions shown. It can be charged in either position.
onto bench stand.
is fully charged, the charger automatically switches to a trickle
wall bracket can be attached by removing the adhesive protective film
/ POWERPETTE
Plus
/ POWERPETTE
Plus
/ POWERPETTE
Plus
/ POWERPETTE
Plus
POWERPETTE.
can be fitted in the bench stand in one
4
OPERATOR
Instructions
is
POWERPETTE