Colibri 5004.002 Manuel D'utilisation page 18

Art.Nr.
No d'art.
5004.002
Nr. art.
Reinstall the filters.
Pay attention to the good position and close the covers by pressing the buttons.
3.2 Installation of foam pads
Install the two foam pads provided below the upper cover if the cleaner climbs the pool wall with
difficulty while the filters are clean. (These are supplementary parts that will be used only in this
special situation)
Open the cover, stick the self-adhesive pads in the place indicated. Same for another side.
To ensure the good contact between the top cover and the pads, don't put the cleaner into water
before 24 hours.
www.colibriproducts.ch | Industriestrasse | CH-5728 Gontenschwil
4-6 4-7
18