Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
(for installation engineers)
BEFORE STARTING:
A)- To ensure simple and effective installa-
tion, first read the section "Useful tips and
warnings" and then these instructions,
strictly observing all steps and sequences
during installation.
B)- The transmitter is compatible with all
Nice receivers operating at the frequency
of 433.92 MHz and which use one of the 4
Nice radio codes (
,
,
fore important to check the radio code of
your receivers, comparing each one with
the data in the table in Fig.
C)- With reference to Step 1, more than
one automation can be associated with
the same Number, but only provided
• the Name of each automation to be
EN
controlled;
• a Number, between 01 and 80, which
from then on will identify the correspon-
ding automation/s;
• the Letter ( ,
,
to the Radio Code used by the Receiver
of each automation.
Note: For this data, consult the table
➌
in Fig.
.
IMPORTANT!: All data written in the
table "Automation List", will be used
to ensure correct completion of the
procedures in this manual.
12
that the Receivers of these automations
have the same type of radio code (see
table in Fig.
recommended when the number of
automations to be controlled is greater
than that admitted on the transmitter.
Otherwise, this operation is not recom-
mended as it limits potential and flexibility
of the entire system.
Radio codes in Nice
Receivers
A
,
). It is there-
B
➌
.
C
D
MEMORISING THE RECEIVER RADIO
CODES IN THE TRANSMITTER
In this step the type of radio code, used by
each of the Receivers installed in your
,
) corresponding
automations, needs to be memorised on
the transmitter. Therefore, with reference
to the data in your "Automation List", pro-
ceed as follows:
01. With the transmitter switched off,
press and hold the key OK for ap-
prox. 10 seconds, until the display
shows the symbol
the text "PROG") then release the key
immediately.
02. Press keys – / + to select the Number
related to the automation to be pro-
grammed.
03. Press keys ▲(1) / ▼(3) to select the
Letter (radio code) associated with the
selected automation, as specified in
your "Automation List".
➌
). This operation is only
For Nice automations of
awnings and shutters (TTS)
For Nice radio controls in the
FLOR series
For Nice radio controls in the
FLO series
For Nice radio controls in the
SMILO series
—
Step 2
—
- - - , (after
—
Step 1
COLLECTING DATA FOR
INSTALLATION
In this step, specific data needs to be
acquired regarding all automations to be
controlled by the transmitter. Therefore, with
reference to the example in Fig.
table "Automation List" at the end of this
manual, and enter the following data:
3
Automation Name
Large gate
Pedestrian gate
Terrace awning
Garage door
Kitchen shutter
Living room shutter
etc...
04. Then press one of the keys – / + to
memorise the entered data. Note: This
operation also automatically selects
the Number of the previous (or next)
automation, which is then ready to be
programmed.
Repeat the procedure described in points
03 and 04 to memorise the radio codes of
the other automations specified in your
"Automation List".
At any time, or at the end of all operations,
the user can exit the procedure by press-
ing ■(2), or by waiting for the transmitter to
switch off automatically.
– See summarised
example in Fig.
—
EN
➍
, use the
No.
Code
01
B
02
D
03
A
04
C
05
A
06
A
.....
.....
4
11
➎
–
Publicité
