Husqvarna 115iHD55 Manuel D'utilisation page 9

Masquer les pouces Voir aussi pour 115iHD55:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1. Stop the product.
2. Remove the battery.
3. Check that the hand guard is attached correctly.
4. Examine the hand guard for damages.
To do a check of the blades and blade guards
The longer parts of the blades (A) operate as blade
guards.
1. Stop the product.
2. Remove the battery.
3. Put on gloves.
4. Make sure that the blades and blade guards are not
damaged or bent. Replace the blades and blade
guards if they are damaged or bent. (Fig. 24)
Battery safety
WARNING: Read the warning instructions
that follow before you use the product.
Only use the BLi battery. Refer to
page 14 . The battery is software encrypted.
Use the BLi battery that is rechargable as a power
supply for the related Husqvarna products only. To
prevent injury, do not use the battery as a power
supply for other devices.
Risk of electrical shock. Do not connect the battery
terminals to keys, coins, screws or other metal. This
can cause a short circuit of the battery.
Do not use non-rechargeable batteries.
Do not put objects into the air slots of the battery.
Keep the battery away from sunlight, heat or open
flame. The battery can cause burns and/or chemical
burns.
Keep the battery away from rain and wet conditions.
Keep the battery away from microwaves and high
pressure.
Do not try to disassemble or break the battery.
If the battery leaks, do not let the liquid touch your
body or eyes. If you have touched the liquid, clean
the area with a large quantity of water and soap, and
get medical aid. If you get liquid in your eyes, do not
rub but flush with water for a minimum of 15 minutes
and get medical aid.
Use the battery in temperatures between -10 °C (14
°F) and 40 °C (114 °F).
Do not clean the battery or the battery charger with
To clean the product, the battery and
water. Refer to
the battery charger on page 12 .
Do not use a defective or damaged battery.
Keep batteries in storage away from metal objects
such as nails, screws or jewelry.
Keep the battery away from children.
1175 - 003 - 17.09.2020
Technical data on
Battery charger safety
WARNING: Read the warning instructions
that follow before you use the product.
Risk of electrical shock or short circuit if the safety
instructions are not obeyed.
Use an approved grounded mains socket that is not
damaged.
Do not use other battery chargers than the one
supplied for your product. Only use Husqvarna QC
chargers when you charge Husqvarna replacement
batteries BLi.
Do not try to disassemble the battery charger.
Do not use a defective or damaged battery charger.
Do not lift the battery charger by the power cord. To
disconnect the battery charger from a mains socket,
pull out the plug. Do not pull the power cord.
Keep all cables and extension leads away from
water, oil and sharp edges. Make sure that the cable
is not caught between doors, fences or similar.
Do not use the battery charger near flammable
materials or materials that can cause corrosion.
Make sure that the battery charger is not covered.
Pull out the plug to the battery charger if there is
smoke or fire.
Only charge the battery indoors in a location with
good airflow and away from sunlight. Do not charge
the battery outdoors. Do not charge the battery in
wet conditions.
Only use the battery charger where the temperature
is between 5 °C (41 °F) and 40 °C (104 °F). Use the
charger in an environment which has a good airflow,
dry and free from dust.
Do not put objects into the cooling slots of the
battery charger.
Do not connect the battery charger terminals to
metal objects as this can short circuit the battery
charger.
Use approved wall sockets that are not damaged.
Use only three-wire outdoor extension cords that
have three-prong grounding plugs and grounding
receptacles that accept the appliance's plug.
Safety instructions for maintenance
WARNING: Read the warning instructions
that follow before you do maintenance on
the product.
Remove the battery before you do maintenance,
other checks or assemble the product.
The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
9

Publicité

Table des Matières
loading

Table des Matières