Assembling The Transport Cart; Electrical Connection; Immersion Of The Robot - Zodiac O'Clair Pool First Notice De Montage Et D'utilisation

2-Notice Poolfirst ANG_Mise en page 1 05/01/11 11:06 Page15

ASSEMBLING THE TRANSPORT CART

Assembling the upper part of the cart.
a) Fit the upper handle tubes (1) and (2) on the control box support hook (3).
b) Then place the cable support hook (4) - the tubes must be turned towards the
cable hook.
c) Place the screw (7) at the top of the cable support and tighten it using the
spanner supplied.
d) Insert the long screws (8) in the control box support whilst maintaining the
nuts (9) in the cable support and tighten them.
Figure 3

ELECTRICAL CONNECTION

For your safety and to guarantee the optimal functioning of your robot, follow the
steps hereunder:
> Place the control box at a distance of at least 3.5 m from the edge of the
swimming pool, avoiding direct exposition to the sun; it can be placed either
on the ground or on the carry cart, as illustrated in
Figure 5

IMMERSION OF THE ROBOT

IMPORTANT: No bathing is allowed whilst the robot is operational in the
in the swimming pool.
Immerse the robot in the water.
own and settles on the bottom of the swimming pool. Ensure that the cable is fully
unrolled in order to reduce twisting and tangling up. Stretch the cable over the
length of the pool. For optimal operation we recommend placing the cart with the
control box at mid-distance of the swimming pool length.
Figure
Final assembly.
a) Place the upper part, as assembled above, on the lower
part of the cart (10).
b) Place the cable support (5) and its cover (6) on the
assembled parts.
Insert the screw (7) at the bottom of the cable support and
tighten it using the spanner supplied.
Insert the 2 long screws (8), in the support cover whilst main-
taining the nuts (9) in the cable support and tighten them.
> Connect the robot cable to the control box and lock the
connector. Figure 5.
> Only plug the control box to a power socket protected with a
residual differential current protection system of 30 mA maximum
(if you have any doubts, contact an electrician/installer).
VERY IMPORTANT! If you use an extension cable in order to
connect your robot to the electrical mains, make sure that
the control box cannot be placed within 3.5 m of the edge
of the swimming pool.
Figure 6. It is essential that the device sinks on its
2.
Figure 3.
Figure 4.
15
a b
c d
Figure 2
Figure 4
Figure 6