Maintaining And Cleaning; Maintaining; Firmware Updating; Fuses Replacement - uideorec ULISSE COMPACT HD PTZ Manuel D'instructions

12 Maintaining and

cleaning

12.1 Maintaining

Maintenance must be carried out by
personnel trained to operate on electrical
circuits.

12.1.1 Firmware updating

The H.264 encoder firmware can be upgraded
directly from the web interface.
If necessary it is possible to update the pan & tilt
firmware.
For further information please contact the VIDEOTEC
service center.

12.1.2 Fuses replacement

CAUTION! For continued protection against
risk of fire, replace only with same type and
rating of fuse. Fuses must be replaced only by
service personnel.
There are two preset fuses on the connection board.
Fig. 56
Their sizes are related to the power supply voltage.
FUSES REPLACEMENT
Voltage Fuse F1
24Vac, 50/60Hz T 4A L 250V 5x20
120Vac, 50/60Hz T 4A L 250V 5x20
230Vac, 50/60Hz T 4A L 250V 5x20
Tab. 8
MNVCUCHD_1511_EN
12.2 Cleaning
The pan & tilt devices require no particular
maintenance. To clean the device use neutral
detergent and a non-abrasive cloth. Remember that
the device is waterproof.
12.2.1 Window and plastic cover
cleaning
We recommend using a soft cloth with neutral soaps
diluted with water or specific products to clean the
glasses lenses.
Fuse F2
T 6.3A H 250V 5x20
T 4A H 250V 5x20
T 2A H 250V 5x20
Avoid ethyl alcohol, solvents, hydrogenated
hydrocarbide, strong acid and alkali. Such
products may irreparably damage the
surface.
33