Preparatory Work Before Installation; Attaching The Bracket; Cables Management; Assembling And Installing - uideorec ULISSE COMPACT HD PTZ Manuel D'instructions

6.4 Preparatory work before

installation

6.4.1 Attaching the bracket

Different types of supports are available (10
Accessories, page 31). Choose a suitable bracket for
the installation and follow all the instructions in the
suggested chapter.
Take special care when attaching and
fastening down the apparatus. If it is to be
attached to a concrete surface you must use
dowel pins with a traction torque rating of
at least 300dN each. For a metal surface use
screws with a diameter of at least 8mm and of
an appropriate length. The clamping system
must be able to support at least 4 times the
weight of the entire equipment, including
P&T, lenses and camera.
The device should be assembled vertically.
Any other position could impair the
performance of the appliance.

6.4.2 Cables management

The connection cables should not be
accessible from the outside. It is necessary
to fasten the cables securely to the support
in order to prevent excessive weight pulling
them out accidentaly.
You must use cables suited to the type of
installation.
Insert the cables into the support so that they
protrude by about 50cm.
50cm
Fig. 6
MNVCUCHD_1511_EN

7 Assembling and installing

The assembly and installation must be
performed only by skilled personnel.
This is a Class A product. In a domestic
environment this product may cause radio
interference. In this case the user may be
required to take adequate measures.
7.1 Installation
Never, under any circumstances, make any
changes or connections that are not shown
in this handbook. Failure to follow the
connection instructions that are given in the
handbook may create serious safety hazards
for people and for the installation.
Do not change the wiring in the product as
it is supplied to you. Failure to follow this
instruction may create serious safety hazards
for people and for the installation, and will
also invalidate the guarantee.
Keep a connection diagram for future
reference.

7.1.1 Connecting the cables to the base

Insert the cables into the cable glands holding the
base at about 20cm from the support. Tighten the
cable glands. The cable glands are suitable for cables
with a diameter between 5mm and 10 mm.
50cm
Fig. 7
13