Publicité
Les langues disponibles
Les langues disponibles
3
Install any internal options
If you plan to use Quick Launch to install your network
operating system, your server must meet the following
minimum requirements to proceed with the server
installation:
16 MB of RAM
SVGA monitor
540 MB minimum hard disk drive
Two or three button mouse
CD-ROM drive with boot capability attached to the
bootable SCSI controller
Keyboard
If you have options to install, install them now.
1. Unlock door (push key in then turn clockwise).
2. Remove side panel.
3. Install options.
Server Installation
Install ISA cards if desired
If you are installing ISA cards, check the current card con-
figuration to avoid IRQ conflicts before manually setting
jumpers and switches. After installing the cards, turn on
the server to run the BIOS Setup utility.
NOTE
If you installed additional SCSI cards, make sure the MS-
DOS partition resides on the drive on which you want it
to be. If not, shut down your server, change the order of
your cards, and reconfigure your server.
CAUTION
Before touching any circuit board or component,
wear an anti-static wrist strap, properly grounded
to the server chassis, or touch the metal frame to
discharge any static electricity.
Refer to the following chapters in the System Reference
manual for detailed information.
Server Software and Utilities
Server Components
Pentium II Processor Upgrades
Installing Additional Memory
Installing Disk and Tape Drives
Installing Expansion Boards
Connecting SCSI adapters
Also, refer to the documentation that came with the option
kit for specific installation instructions.
5
Publicité
