Makita GA7030 Manuel D'instructions page 8

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing side grip (handle)
006735
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing wheel guard
CAUTION:
When using a
•
wheel/Multi-disc, flex wheel or wire wheel brush,
the wheel guard must be fitted on the tool so that
the closed side of the guard always points toward
the operator.
For tool with locking screw type wheel guard
006736
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard around 180 degrees
counterclockwise. Be sure to tighten the screw securely.
To remove wheel
procedure in reverse.
depressed center
1. Wheel guard
1
2. Screw
3. Bearing box
2
3
guard, follow the
For tool with clamp lever type wheel guard
1
007049
1
007050
Loosen the lever on the wheel guard. Mount the wheel
guard with the protrusion on the wheel guard band
aligned with the notch on the bearing box. Then rotate
the wheel guard around to the position shown in the
figure. Tighten the lever to fasten the wheel guard. If the
lever is too tight or too loose to fasten the wheel guard,
loosen or tighten the nut by spanner to adjust the
grinding
tightening of the wheel guard band.
To remove
procedure in reverse.
Installing or removing depressed center
grinding wheel/Multi-disc (accessory)
006737
WARNING:
Always use supplied guard when depressed
•
center grinding wheel/Multi-disc is on tool. Wheel
can shatter during use and guard helps to reduce
installation
chances of personal injury.
NOTE:
In countries other than United States and Canada,
•
Inner flange 45 can be also used.
Mount the inner flange onto the spindle. Fit the wheel/disc
on the inner flange and screw the lock nut with its
protrusion facing downward (facing toward the wheel).
8
1. Bearing box
2
2. Wheel guard
3. Nut
4. Lever
3
4
1. Nut
wheel guard, follow
1. Lock nut
1
2. Depressed
2
3
3. Inner flange
the installation
center grinding
wheel/Multi-disc