Makita GA7030 Manuel D'instructions page 11

For United States and Canada
Installing or removing abrasive cut-off wheel/
diamond wheel (optional accessory)
45
1
78
2
3
78
4
010946
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may result.
The tool and its air vents have to be kept clean.
Regularly clean the tool's air vents or whenever the
vents start to become obstructed.
1
006744
Replacing carbon brushes
1
001146
1. Lock nut
2. Outer flange 78
3. Abrasive cut-off
wheel/diamond
wheel
4. Inner flange 78
5. Wheel guard for
abrasive cut-off
wheel/diamond
wheel
5
1. Exhaust vent
2. Inhalation vent
2
1. Commutator
2. Insulating tip
2
3. Carbon brush
3
When the resin insulating tip inside the carbon brush is
exposed to contact the commutator, it will automatically
shut off the motor. When this occurs, both carbon
brushes should be replaced. Keep the carbon brushes
clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only
identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1
2
006745
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
Your tool is supplied with a guard for use with any
•
recommended grinding wheel, multi-disc, flex
wheel and wire wheel brush. If a diamond wheel
and/or cut-off wheel are also available for use with
the tool, they should only be used with the
appropriate optional guard for cut-off wheels.
If you decide to use your Makita grinder with
approved accessories which you purchase from
your Makita distributor or factory service center, be
sure to obtain and use all necessary fasteners and
guards as recommended in this manual. Your
failure to do so could result in personal injury to
you and others.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
11
1. Brush holder
cap
2. Screwdriver
or attachments
Only use accessory or
are