Attaching The Range Hood To The Ceiling - Foster MILANO ISLAND 36 Mode D'emploi

Fix Bracket "C" to the power unit with the
nuts and washers supplied (Items "A" on the
schematic on page 5). Please ensure that
the bracket is installed as shown to enable
full ac-cess to the square plastic black box
and the metal electrical junction box. Slide
Bracket "B" over Bracket "C" (once again
ensure full access to the plastic and electri-
cal boxes is main-tained) and fix it in place,
at the previously calculated length using the
machine screws denoted by items "B" on the
schematic on page 5.
Check that the plastic flaps at the exhaust
outlet for the fan move freely and have not
become jammed during shipping or whilst
working with the power unit. Connect an ap-
propriate length of ducting to the unit.
Do not fix the ducting to the outlet with
screws - use DUCT TAPE.
Stand the assembled structure on a clean
soft surface. Ensure the underside of the
hood does not get scratched and slide the
chimneys of the assembled structure from
the top down as per the schematic on page
5. Ensure that the holes for fixing the deco-
rative chimney are correctly orientated with
the holes at the top of bracket A.

Attaching the Range Hood to the Ceiling.

The entire structure that has been pre-as-
sembled above, must now be hoisted up to
the ceiling. A few things have to happen at
once here: the slots (as discussed below)
need to be engaged and the ductwork must
make connection with the length of ductwork
on the structure.
This will require two strong people –do not
attempt this step on your own. Bracket "B"
has slots, position C per Diagram "A" (refer
to page 5), at the top that will receive the
spring clips located on Bracket "A" -THIS IS
A TEMPORARY HOLD ONLY –DO NOT
RELY SOLELY ON THESE CLIPS TO
HOLD THE HOOD UP – THEY WON'T.
Once "hooked" by the spring clips immedia-
tely secure the structure with the machine
screws at point "E" on the schematic on
page 5 – this must be done immediate-
ly and should not be skipped. Raise the
upper chimney to the ceiling and fix it to the
bracket "A" with the screws supplied "D".
Ensure the entire structure is sturdy - serious
injury, death and MAJOR damage could re-
sult should the unit not be well connected to
the frame structure within the ceiling.
This is of utmost importance - do not go any
further until this has been tested and double
checked - the installer has sole responsibi-
lity for the safe installation of this product.
Attaching the Range Hood to the Ceiling.
The entire structure that has been pre-as-
sembled above, must now be hoisted up to
the ceiling. A few things have to happen at
once here: the slots (as discussed below)
need to be engaged and the ductwork must
make connection with the length of ductwork
on the structure.
7