goodnature A24 Trap Manuel D'utilisateur page 9

13.
REMOVE ALP SCREW CAP
Now remove the ALP Screw Cap. A small amount of lure may be
forced out, that's fine – there's still enough lure for 6 months.
Wipe this excess lure below the entrance to your trap to start
attracting pests.
15.
REPLACE THE GAS & LURE EVERY 6 MONTHS
Your ALP will last for 6 months. Make a note of when you'll need
to replace your lure. This keeps your lure fresh and attractive to
pests. It's a good idea to replace your gas canister at the same
time, so your trap is powered and ready for action.
14.
SCREW & SECURE THE SHROUD CAP & ALP
Place the Shroud Cap with the ALP into the Lure Cradle and
screw into the internal thread with a few turns. Once the ALP is
screwed into the Lure Cradle, secure the Shroud Cap onto the
trap by pushing down and clicking into place with another turn.
The ALP is now set and active!
16.
CHECKING THE COUNTER
To check the tally on the Counter, quickly press and release the
button. The display will show the number killed. Pressing and
holding the button down zeroes the Counter.
English
9