goodnature A24 Trap Manuel D'utilisateur page 8

Masquer les pouces Voir aussi pour A24 Trap:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

English
7.
POWER UP YOUR TRAP
Remove the black cap from the gas canister. Be careful to keep
the screw thread clean and free of debris. Screw the canister
firmly into the trap. Hand tighten only.
9.
ZERO THE COUNTER
Zero the Counter by pressing the button and holding it down
until the display shows '00'. The Counter goes to sleep a few
seconds after the button is released.
11.
ACTIVATE THE AUTOMATIC LURE PUMP
Remove the 10c coin from the top of the Automatic Lure Pump
(ALP) just before you put it into the Shroud Cap. This activates
the technology which will dispense lure for 6 months. It is vital
you remove the coin or the ALP will not activate.
8
8.
ATTACH THE DIGITAL STRIKE COUNTER
If you purchased a Counter with your A24, slightly wet the inside
of the rubber strap for lubrication and rotate the Counter anti-
clockwise as you ease it up the canister. The Counter display
must face directly away from the trap.
10.
TEST-FIRE YOUR TRAP
To test fire the trap, reach a pen or twig down through the top of
the trap and push the Trigger gently to the side. The Striker will
fire with a bang and then retract. Always keep your hands clear
of trap entrances and always treat the trap as live.
12.
NEST ALP INTO SHROUD CAP
With the ALP activated, gently squeeze and shape the ALP
into the Shroud Cap. It will be a tight fit. Push the ALP into the
Shroud Cap until its skirted edge sits aligned with the edge of
the Shroud Cap rim. It will then easily screw into the Lure Cradle.

Publicité

Table des Matières
loading

Table des Matières