Installing Your Traps - goodnature A24 Trap Manuel D'utilisateur

INSTALLING YOUR TRAP
1.
INSTALL YOUR DETECTOR CARDS
To find the best location for your trap, use Detector Cards,
leaving them in place for three nights. Install your trap where
rodents have interacted with the cards.
3.
ATTACH THE TRAP MOUNT
Using a screwdriver, screw in the orange Trap Mount 12cm
(about a hand width) above the ground onto a straight tree or
post. Do not overtighten the screws.
5.
IF ATTACHING TO A TRAP STAND
Guide the top slot at the rear of the A24 onto the upper central
locking tab of the stand. Once these are coupled, gently ease
the trap into the stand and it will click into the lower locking tab.
It is easiest done when you don't force it. The trap is mounted
correctly when there is no gap between the A24 and stand.
2.
SEPARATE TRAP MOUNT FROM THE TRAP BODY
Using your forefinger and thumb, press the Black Tabs inwards
and ease the orange Trap Mount along and off the Trap Body.
4.
CLICK THE TRAP BODY INTO THE TRAP MOUNT
Tilt the Trap Body backwards slightly and lower it onto the top
locking tab of the Trap Mount. As you press downwards the
Trap Body will be guided in toward the Trap Mount and lock in
with a click.
6.
A24 TRAP STAND
Secure the A24 to the stand by closing the orange Stand Lock.
You will hear a 'click' when it is in place. Place your trap stand
on a flat surface or ground. There are two peg holes at either
end of the stand that you can use to keep the trap upright when
situating it on an uneven surface.
English
7