Publicité
Les langues disponibles
Les langues disponibles
KTX 3
Control Panel
time settings
(clock/dryer/timer) –
Display Panel
MANUAL MODE
Heating element heats the radiator that it is installed in and, at the same time, controls
its temperature.
For temperature regulation please use buttons
temperature measured inside the radiator. After settings have been modified, display
panel will flash showing the newly set temperature for a few seconds and will go back to
displaying current temperature. Heating indicator
the newly set temperature is higher than the current one.
In order to view the set temperature, please press any of the parameters regulation
buttons once.
Construction of the device as well as physical characteristics of the heating agent inside
the radiator influence the way in which the heat is distributed – the temperature of the
bottom pipes of the radiator (especially the two located at the very bottom of the radia-
tor) may be lower than the temperature of the remaining parts of the radiator – this
is a normal phenomenon.
– on/off button
– parameters regulation
and
. LCD display panel shows current
will come up on the display panel if
Turning the device on does not mean that it uses the same maximum power for the whole
time it is on. On turning the device on, it operates with the nominal power for a short
period of time in order to heat up the radiator to the set temperature. After that it turns
itself on and off periodically, using only as much energy as it is required to maintain the
set temperature of the radiator for current external conditions.
ANTI-FREEZE FUNCTION
When the device is off and temperature around the temperature sensor drops down
below 6°C, the device will switch on automatically. This is to prevent the heating agent
inside the radiator from freezing. Display panel will show AF code.
DRYER MODE
Dryer mode allows to turn the device on for a certain length of time, ie. in order dry
a towel. After the set length of time the device will go back to the setting from before
the dryer mode has been activated.
You switch the dryer on by quickly pressing
temperature of 50°C, drying time: 2 hours. Any subsequent quick pressing of the button
will prolong the drying time by 0.5 hour up to 4 hours. Having reached
4 hours, the clock goes back to the start on pressing the
Small numeric field displays exact drying time left,
while the big one shows the same time rounded
to a full hour.
If the device had been off before the dryer was
activated, it will turn off automatically after the
dryer mode is finished.
In order to interrupt the dryer mode at any time, please press
CLOCK
Current time (hh:mm) is displayed both when the device is on and when it is off with an
exception of the dryer activation time or when the device is being programmed.
once – Dryer default parameters are:
button again.
.
Publicité
