Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Getting to know Your Speaker Package—Continued
Caution:
A mounting screw's ability to support a speaker depends
on how well it's anchored to the wall. If you have hollow
walls, screw each mounting screw into a stud. If there are
no studs, or the walls are solid, use suitable wall anchors.
Use screws with a head diameter of 3/8" or less and a
shank diameter of 1/8" or less. With hollow walls, use a
cable/pipe detector to check for any power cables or
water pipes before making any holes.
Leave a gap of between 1/4" and 5/16" between the wall
and the base of the screw head, as shown.
Wall
1/4"–5/16"
(We recommend that you consult a home installation
professional.)
Subwoofer (SKW-750)
■ Front
■ Rear
2
To AC outlet
A
STANDBY/ON indicator
Red:
Subwoofer in standby mode
Blue:
Subwoofer on
With the Auto Standby function, the SKW-750
automatically turns on when an input signal is
detected in Standby mode. When there's no input
signal for a while, the SKW-750 automatically
enters Standby mode.
B
OUTPUT LEVEL control
This control is used to adjust the volume of the sub-
woofer.
C
LINE INPUT
This RCA input should be connected to the sub-
woofer pre out on your AV receiver, amp, or other
receiver with supplied RCA cable.
Note:
The Auto Standby function turns the subwoofer on when
the input signal exceeds a certain level. If the Auto
Standby function does not work reliably, try slightly
increasing or decreasing the subwoofer output level on
your receiver or amp.
1
3
En-
5
Publicité
Table des Matières
