Dri-Eaz DefendAir HEPA 500 F284-230V Manuel De L'utilisateur page 5

WARNING
Electric Shock Hazard
Unplug unit before performing
any maintenance.
Never use a water hose or pres-
sure washer to clean electrical
components; water could enter
the electrical compartment caus-
ing a shock hazard.
Follow cleaning instructions in
manual.
07-01496 Copyright 2005 Dri-Eaz Products, Inc.
READ AND SAVE THESE INSTRUCTIONS
Resources
• Dri-Eaz Guide to Airscrubbing, call Dri-Eaz at 0800-542-9609.
• S520: The Standard and Reference Guide for Professional Mold Remediation,
call the IICRC at 360-693-5675 (USA).
• Institute of Inspection, Cleaning and Restoration Certification (IICRC), 360-693-
5675.
• Dri-Eaz website and Virtual Training Center (VTC) at www.dri-eaz.eu.com
• Dri-Eaz Education Department, 0800-542-9609
• Contact the Health and Safety Executive for respirator and respirator filter
information at 08701-545500, or visit www.hse.gov.uk/pubns/wis14.pdf for an
instruction sheet. You can also contact NIOSH in the US at 1-800-35-NIOSH.
M
AINTENANCE
Before Each Use
Always wear Health Safety Executive (or your country's equivilant safety regula-
tory body) recommended respirator and personal protective equipment when
removing or replacing filters, or when cleaning the DefendAir HEPA 500.
•
Inspect the electrical cord for damage. Look for fraying, cuts, etc. Do not use the
unit if you find any. Call Dri-Eaz for the nearest Service Center.
When using the DefendAir HEPA 500 for water damage restoration:
When using the DefendAir HEPA 500 for remediation:
After every job
Maintenance
I
NTERVALS
WARNING
ELECTRIC SHOCK HAZARD
Unplug the DefendAir HEPA 500 before performing maintenance.
WARNING
CONTAMINATION HAZARD
• Inspect pre-filter before each use. Look for accumulated dust and dirt
that could restrict airflow through the filter into the unit. If any is visible,
change out the pre-filter.
• Replace the HEPA filter when the Change Indicator Light comes on.
Note:To be assured of true HEPA filtration, change the HEPA filter after
every water damage job, or when the indicator light comes on; whichever
occurs first.
• Replace both the filters to prevent cross-contamination.
• Clean the unit thoroughly (vacuum and damp wipe per IICRC S520,
10.11) after each job before removing it from the containment area to
avoid cross-contamination. Pay particular attention to the area around
the air intake. Let the unit dry before installing clean filters.
5