Synchronising The Remote Control - SERVETTO i3 Guide De Montage

Electric Servetto i3
Press the remote control button again to raise the arms back up.
The Electric Servetto i3 is now installed and working: the clothes rail tube can now accommodate your clothing.
The Electric Servetto i3 can be stopped at any time by pressing the button on the remote control. When the remote control
button is pressed again, the Electric Servetto i3 will move in the opposite direction.
The Electric Servetto i3 can also be operated by pressing the activation button (No. 15 on Fig. 2), located on one of the two arms.
WARNING: If the Electric Servetto i3 stops and BEEPS twice during the ascent phase, this means that the load
capacity has been exceeded. Press the remote control button once more and the Electric Servetto i3 will lower
back down. Remove some clothes and try again.

6 SYNCHRONISING THE REMOTE CONTROL

ATTENTION: The included 1-button remote control is already programmed.
Repeat the synchronising only if necessary.
The 4 or 12-buttons remote controls, available as an optional, must be synchronized following the steps below.
To synchronise the Electric Servetto i3 with the desired remote control, the following procedure must be performed:
1 - Press and hold the programming button (Fig. 22) for 5 seconds; when released, the control unit will "BEEP" twice.
2 - Press the desired button on the remote control (Fig. 23) and it will "BEEP" again.
The Electric Servetto i3 has now been synchronized with the selected button for the up/down command.
Available remote controls (Fig.3):
A) 1-button remote control, included
B) 4-buttons remote control, optional (art. SWCO02504)
C) 12-buttons remote control, optional (art. SWCO02512)
Fig. 23
17
Fig. 22