Inglis W11035214A Guide D'utilisation page 14

Troubleshooting
First try the solutions suggested here or visit our website at inglis.ca for assistance and to possibly avoid a service call.
Water Leaks
Check the following
for proper installation:
Washer not performing as expected
Not enough water
in washer
Washer won't run
or ll, washer stops
working, or wash light
remains on (indicating
that the washer was
unable to ll
appropriately)
Washer won't run
or ll, washer stops
working, or wash light
remains on (indicating
that the washer was
unable to ll
appropriately) (cont.)
14
Washer not level.
Fill hoses not attached tightly.
Fill hose washers.
Drain hose connection.
Check household plumbing for leaks
or clogged sink or drain.
Washer not loaded as recommended. Improper loading can cause basket to be out of alignment
Load not completely covered
in water.
Check for proper water supply.
Check proper electrical supply.
Water may splash off basket if washer is not level. Check that
load is not unbalanced or tightly packed.
Tighten ll hose connection.
Make sure all four ll hose at washers are properly seated.
Pull drain hose from washer cabinet and properly secure it
to drain pipe or laundry tub.
Do not place tape over drain opening.
Water can back up out of a clogged sink or drain pipe. Check
all household plumbing for leaks (laundry tubs, drain pipe, water
pipes, and faucets).
and cause water to splash off tub. See "Using Your Washer"
for loading instructions.
This is normal operation for a high ef ciency washer. If the Water
Level knob is set to Auto Sensing, the load will not be completely
under water. The washer senses load sizes and adds correct
amount of water for optimal cleaning. Use Bulky/Sheets cycle
for higher water ll, or set Water Level knob to Deep Water Wash
setting. See "What's Under the Lid" and "Cycle Guide" to match
your load with the best cycle.
IMPORTANT: Do not add more water to washer. Adding water
results in less effective cleaning.
Run Clean Washer with affresh
and wash performance due to soil buildup in washer basket.
Both hoses must be attached and have water owing to
inlet valve.
Both hot and cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check inlet hoses for any kinks, which can restrict water ow.
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
cycle to optimize the water level
®