The Television Functions; Television Via Satellite (Dvb-S) - Caratec CAV191 Notice D'utilisation

6. The Television Functions

Note: Depending on the location, the search run can take up to 20 minutes. If the search
run is interrupted, the list of channels is incomplete or even empty. However, you can
reset the list of channels to the delivery status.

6.1. Television via Satellite (DVB-S)

Connection
Connect the satellite dish and the set with a conventional coaxial cable to the "DVB-S-Tuner"
inlet. Align the dish to the required satellites.
Automatic Channel Search Run
To start an automatic channel search run, proceed as follows:
1. Select "DVB-S" as the source.
2. Press the "LCD MENU" button on your remote control.
3. Choose the "Auto Scan" function.
4. Press "OK".
5. You can configure the search run in the following window.
Manual Channel Search
To carry out a manual channel search, proceed as follows:
1. Select "DVB-S" as the source.
2. Press the "LCD MENU" button on your remote control.
3. Select the function "Dish setup" in the "Channel" level.
4. Select the required satellite or transponder and mark it with "OK".
5. Press the blue button on your remote control and select the following in the following
window:
Scan Mode
Channel Type
Service Type
Polarizati on
6. Start the search run by pressing the blue button on your remote control.
7. After ending the channel tuning, a TV image appears if a signal exists.
* Scan Mode
Default
Blind Scan
Network
44
>Blind Scan<*
>All<
>All<
>Auto<
Explanation
Scanning the known transponder on the satellite.
Complete scan over the full frequency spectrum of a satellite without use of
presets.
Scan with the help of a transponder list transmitted by satellite.