General Information - Caratec CAV191 Notice D'utilisation

1. General Information

To prevent damage to your appliance, please observe the following points during the initial
start-up and use of it.
Establishing the power supply
Mounting to a wall bracket
Cleaning the appliance
LED display
Heat / Humidity
Condensation
Air circulation
Small parts
30
Connection is only possible to a 12V power supply, observe correct
polarity. For cable lengths of more than 5 m, a cable cross-section
of min. 2 x 2.5 mm² must be used.
Ensure that the mounting screws are not too long. The screws
(M4) must not protrude into the appliance by more than 10 mm.
Prior to cleaning disconnect the power supply line. Do not use
detergents, do only clean with a soft humid cloth or special
detergents for flat screens.
The appliance can become damaged by heavy pressure onto the
screen surface.
The appliance should be exposed neither to extreme heat
(direct sunlight, radiator, open flame) nor to water and humidity,
respectively.
After moving from a cold environment to a warm environment,
the appliance must be left to stand for at least an hour without
being connected to a power outlet. A rapid change in temperature
can lead to the build-up of condensation in the appliance, which
causes damage when in operation.
To prevent the appliance from overheating, the vent holes on the
back must always be kept clear.
Please ensure that no small parts or liquids penetrate the appliance.
This can lead to damage to the appliance or even to fire.